Rebooting The System (Web Interface) - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller Administrator's Guide
To manage installed images:
1. View the images installed on the two boot partitions.
2. Click Switch Boot Partition if the image you want to install is in the other partition.
3. Click Save at the top of the page to make changes persistent across reboots.
Install New Image
To set partition; use Switch Boot Partition, above, if needed. See
To install a new image:
1. Select the appropriate radio buttons and enter this information, respectively:
• Install from URL—Enter the URL and file path of the install image.
• Install via SCP—Enter the URL and file path of the install image and a Password
allowing access.
• Install from local file—Use the Browse button to locate the file on your local system.
2. Select installation options:
• View image upgrade process— When this is checked, you get a progress bar and
status messages of the upgrade process.
• Image validation, choose from the drop-down list:
•
•
•
3. Click Install Image. A progress bar is displayed showing the image install.
4. To complete the upgrade, go to the Reboot page and reboot the system.
5. Click Save at the top of the page to make changes persistent across reboots.

Rebooting the System (Web Interface)

A reboot brings up the same configuration that was last active.
To reboot or shutdown the appliance:
•
From the left navigation pane in the System Config tab, select Reboot.
The System Reboot or Shutdown page is displayed. See
Figure 37 System Config > Reboot Page Detail
Validate if signature is present
Require signature and validate
Ignore signature
Media Flow Controller Configuration Tasks (Web Interface)
Rebooting the System (Web Interface)
Figure 36.
Figure 37.
157