Figure 54 Service Config > Namespace Configure Page Detail (Match Details) - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller Administrator's Guide
• Virtual-host—Enter the address and port (optional) of a virtual host.
•
2. Click Apply.
3. Click Done at the bottom of the page if you are finished.
Figure 54 Service Config > Namespace Configure Page Detail (Match Details)
Configuring Namespace Parameters (Web Interface)
Set cache inherit, status, virtual player, and delivery protocol options. See
To configure namespace Parameters:
1. Enter this information to the text boxes or select the checkbox as described:
• Cache Inherit—Add the specified namespace's cache to this one; see
namespace cache-inherit" on page
• Status Active—Activate the namespace; de-select to de-activate but not delete.
• Virtual Player—Assign an existing virtual player to this namespace; the virtual player
settings override the global network connection settings (for this namespace).
• Delivery Protocol—Set a protocol for responses from this namespace.
2. Click Apply.
3. Click Done at the bottom of the page if you are finished.
virtual-IP and virtual-port—The IP address must be a /32 address; it can be
0.0.0.0, which means any IP address. Port number specification is optional. To
map requests by TCP port number only, set the IP address to 0.0.0.0 and
configure the port number. If you set the domain to any, configure virtual-host IP
to 0.0.0.0, then requests can be assigned to a namespace based solely on the
port number on which the request comes in to Media Flow Controller. Optionally,
set a precedence (defined above).
Media Flow Controller Configuration Tasks (Web Interface)
82, for details.
Configuring NameSpaces (Web Interface)
Figure 55.
"Using
183