Clear - Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual

JUNOS 10.4 Protected System Domain Configuration Guide

clear

Syntax
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
List of Sample Output
Output Fields
clear clear
58
clear -config -T system:mm[x]
Command supported by Junos OS Release 9.1 and later.
(JCS management module CLI) Restore the JCS management module configuration to
the default settings.
NOTE: Use this command to clear the JCS management module configuration
only. Do not clear the JCS switch module configuration.
—Specify the configuration is to be cleared.
-config
-T system:mm[x] —Specify the management module as the target of the command (the
configuration to be cleared). Replace x with a value of
supervisor
Restoring the Default JCS Management Module Configuration on page 40
power on page 224
clear on page 58
No results are returned from this command. After the JCS management module resets,
you must start a new CLI session.
system> clear —config –T system:mm[1]
or .
1 2
Copyright © 2010, Juniper Networks, Inc.