3D Systems FIGURE 4 MODULAR User Manual page 96

1. If there is a platform with a part on it currently in the
machine: remove it, wearing nitrile gloves, according to
the section Remove Print Platform
Guide. Hold a drip tray underneath the part to catch any
material dripping off the part.
1. Verify the platform has been
visibly warped. A properly cleaned print platform will not
have any residual print material or contaminants of any
kind present. Special attention should be paid to the print
surface (1), and elevator guides (2).
2. Also make sure the elevator is at its upper limit, or offload,
position before installing the platform. The elevator should
have moved to this position after the previous job. If it
did not, cease printing and restart the printer. If the issue
persists, contact 3D Systems Service.
3D Systems, Inc.
in the Post-Processing
properly cleaned and is not
92 p/n 42-D116, Rev. K