First Aid And Protective Equipment - 3D Systems FIGURE 4 MODULAR User Manual

1. Press the lit power button in the upper-right-hand corner
of the Printer. This cuts power from the 24v power supply
to the rest of the machine. This does not cut the current
going from the wall to the power supply.
Controller
There are two different ways to shut down the Controller:
1. Pull the power cord out the back of the unit. This
disconnects all electric current going to the computer's
power supply. As such, it is the preferred method of
shutting down the Controller in an emergency. This does
NOT shut down any of the Printers. It only stops the print
queue from processing any more jobs.
1. Turn the power switch, above the power inlet, to the O
position.

2.7 First Aid and Protective Equipment

The following paragraphs provide general first-aid procedures and recommendations for protective equipment to minimize
the risks from material exposure. If professional medical attention is necessary, take the Safety Data Sheet (SDS) for the exact
material involved to the attending physician.
Skin Contact
Wear Protective Gloves: Figure 4 material may cause sensitization by skin contact. It is irritating to the skin;
repeated and/or prolonged contact may cause dermatitis. Wear 100% nitrile gloves and lab coats to avoid
skin contact. Should material come in contact with skin, wash thoroughly with soap and COLD water and
immediately remove contaminated clothing and shoes. If skin is irritated, get medical attention. Dry-clean
contaminated clothing. Discard contaminated shoes and leather products.
3D Systems, Inc. 10 p/n 42-D116, Rev. K