3D Systems FIGURE 4 MODULAR User Manual page 134

1. Power the Printer on by pressing the power button on the
top front. Ensure that:
a. The Printer has an IP address - swipe left on the
Printer's local display to view this.
b. The Printer is connected to your Controller - On the
Controller, view the status screen and ensure that the
Printer's status is "ready."
1. Reinstall your resin tray, print platform, and material
cartridge that you uninstalled in Step 4.
You are now ready to print with your relocated Printer. If you
experience any issues, contact 3D Systems Service.
Moving the Controller
No special supplies are needed to move the Controller.
1. Shut down the Controller by flipping the power switch on
the back of the unit to the 0 position.
3D Systems, Inc. 130 p/n 42-D116, Rev. K