3D Systems FIGURE 4 MODULAR User Manual page 73

6.1.1.1.4.1 Printer Network Settings
6.1.1.1.5 Resin Tray Card
3D Systems, Inc.
IP Address/DHCP - The IP address of the
A
Printer. When DHCP is enabled, your network
will automatically assign an IP address to the
unit. When DHCP is disabled, your network
administrator will be able to manually assign an
IP address to the unit. Tap the DHCP switch on-
screen to turn this off and be able to manually
enter network information.
MAC Address - A hardware address for the
B
network adapter in the Printer's computer. For
display only. This cannot be changed through this
interface.
Network Interface Attributes - These are all values
C
that can be changed when DHCP is turned off.
Contact your network administrator.
Renew DHCP Lease - Tap the
D
button to manually renew the Printer's IP address.
Save - Tap this button to save the current network
E
settings for the Printer.
Status - This indicates the current state of
A
the resin tray: not present, tensioned, and
untensioned. Please see the section
Status for more information.
Run Cleaning Job Button - Tap this button to
B
initiate a resin-tray cleaning job. You should run
this job only if you have had a failed build
or if partially cured material is floating in the
resin tray. Please see the section Running a
Resin Tray Cleaning After a Failed Build
information.
69
Resin Tray
for more
p/n 42-D116, Rev. K