Editing Build File Properties - 3D Systems FIGURE 4 MODULAR User Manual

5. Once the first build-file upload completes, you will start
to see screens like the one at the right for each build file
uploaded. If desired, fill out a Description (1) for your print
job(s). You are required to select a Module (2) to which to send
the print job. All other fields are read-only. Auto is selected by
default; but you can tap the dropdown menu to see a list of all
Printers connected to this Controller. Select one of the units
under the heading MODULES WITH SAME MATERIAL. Please
see the section Job Queue Assignment
Auto and Manual print queue assignment.
CAUTION: Selecting a Printer from under the
heading, "MODULES WITH OTHER MATERIALS,"
is not advised. The material selected for the job
in 3D Sprint drives the creation of supporting
architecture and other printer settings that
are optimized for that material. Printing a
job intended for one material with a different
material strongly risks a failed build and, thus,
wasted material.
6. Once you have filled out all the screens from Step 5, the
Add Job wizard will close and send you back to the Queue tab.
Whether you chose Auto or Manual job assignment, your print
job(s) will appear in one of two sections of the Queue:
1. Active Print Jobs - If the assigned Printer IS ready to print,
your job will appear here. The print job will begin on the
assigned unit.
2. Pending Print Jobs - If the assigned Printer is NOT ready
to print, your job will appear here. Within this section, you
may tap on a print job to select it and move it throughout
the print queue using the control buttons (c) at the top of
the screen.

6.7.2 Editing Build File Properties

If you sent your print job from 3D Sprint directly to the Controller over your network, the job will automatically appear in the
Pending Print Jobs section of the Queue screen. It will take on all default settings from the Controller, such as Auto/Manual Job
Assignment. However, while the job is still in Pending status, you can change its information. To do this:
1. On the Queue screen, tap the print job for which you wish to change the information.
3D Systems, Inc.
for a full explanation of
110 p/n 42-D116, Rev. K