Clean Print Platform - 3D Systems FIGURE 4 MODULAR User Manual

→
You can also store the resin tray in the printer with the cover from the garage on top, as seen below.
CAUTION: When covering the resin tray inside the printer, do NOT press down on the cover. The resin-tray
membrane is sitting on the membrane lip while in the machine, meaning that even a small amount of
pressure can damage the membrane.

7.1.3 Clean Print Platform

You must clean the print platform after each use. This section assumes you have already taken steps in the
Guide to remove the printed part from the print platform
CAUTION: Do not clean the print platform in a sink or tub that drains into waste water. This component must
be cleaned in a self-contained tub and the resulting solvent/material mix must be discarded according to all
local, state, and federal regulations.
WEAR 100% nitrile gloves throughout this procedure.
3D Systems, Inc.
.
142
Post-Processing
p/n 42-D116, Rev. K