Clean Membrane-Interface Lip - 3D Systems FIGURE 4 MODULAR User Manual

1. While in solvent, use the Wire Brush to scrape the
remaining partially cured material from the platform.
1. Wipe down the platform with a lint-free paper towel or
nonabrasive cloth.
1. Inspect the platform, particularly the holes on the flat
surface, to ensure no partially cured material remains. If
you find material or partially cured bits on the platform
at this point, follow the steps in this section again on the
problem areas.
2. Allow the platform an hour to dry. Use compressed air to
speed up this process, if desired.
Your print platform is now clean and ready to be reused.

7.1.4 Clean Membrane-Interface Lip

It would be good to perform this procedure while your resin tray
The membrane interface lip is pictured below. It is the part of the chassis that makes contact with the resin-tray membrane.
If the lip has dust, debris, or material on it, clean it with IPA and a nonabrasive cloth. Inspect the lip for any damage, as chips or
cracks affect the tension of the resin-tray membrane during printing.
3D Systems, Inc.
is being cleaned , so that it is already out of the machine.
146 p/n 42-D116, Rev. K