Power On Modular System; Installing-Setting Up 3D Sprint Software - 3D Systems FIGURE 4 MODULAR User Manual

5 FIGURE 4 MODULAR SYSTEM REQUIREMENTS AND SETUP
System Requirements
Included with the system is the part-preparation (3DSprint
building functionality. The 3DSprint software is installed on a separate, customer-supplied computer. The following page
contains the minimum computer configuration requirements for the 3D Sprint computer:
article/3D-Sprint?language=en_US

5.1 Power on Modular System

Your 3D Systems certified installer should have powered on your system for you. However, if the system or any of its
components have unexpectedly shut down, or if you have shut them down, this section describes how to start up the system's
components.
Power on Controller
1. Ensure the power cable is connected on the Controller side
and at the wall.
2. The power button is located just above the power inlet. Flip
this to the I position.
3. Give the system a few moments to boot up. The
Controller's touch screen will eventually bring up the
Modular GUI (graphical user interface).
4. This does not power on the Printers.
Power on Printer
CAUTION: Ensure that all machine doors are closed before starting it up.
1. Ensure the power cable is connected on the Printer side
and at the wall.
2. Press the power buttons on all Printers.
1. The LED in the power button will turn white and, assuming
all printable conditions
screen at the right. If those conditions are not met, you will
see screens instructing you on what to do for the machine
to be ready to print.

5.2 Installing-Setting Up 3D Sprint Software

Note: 3D Sprint software is always subject to updates. An announcement, along with release notes, will
accompany a new software-version release.
You should have received a 3D Sprint install file and activation code from your 3D Systems representative. Before installing 3D
Sprint, you may have to update some settings on your computer and graphics card. Please read the 3D Sprint Installation Guide
for procedures on this and for full installation instructions
3D Systems, Inc.
. Scroll down and click the 3D Sprint System Requirements link.
are met, the GUI will boot up to the
) software. This application provides part preparation and part
™
55
https://support.3dsystems.com/s/
p/n 42-D116, Rev. K