3D Systems FIGURE 4 MODULAR User Manual page 143

1. Pour the contents of the tray over the tray corner into your hazardous waste container. The Resin Mixer may be used to
guide material and debris out of the tray. If you wish to retain this material, you could pour into another compatible resin
tray and place that tray in its garage for later use.
CAUTION: Do NOT use the Platform Scraper to clean the resin tray, as it will easily puncture the membrane
at the bottom of the tray.
CAUTION: Do NOT pour the material back into the cartridge. Doing so risks contamination, and/or improper
mixture of material in the cartridge. This could result in undesirable build quality or build failure.
1. Place tray in its garage.
Tip: You may place a paper towel or clean-
room wipe on your cleaning surface, so as
not to get material and/or solvent directly on
it. This can also prevent foreign debris from
dirtying or puncturing the tray's membrane. If
you use this tip, be sure to discard the paper
towel/wipe after each cleaning, according to all
government regulations.
3D Systems, Inc. 139 p/n 42-D116, Rev. K