3D Systems FIGURE 4 MODULAR User Manual page 119

2. You will also see the message at the right on Controller
screen.
3. Please see the section Recover from Resin-Tray Leak
more information.
6.7.3.1 After Aborting
For most methods of aborting a print job, please perform the steps below. If your job was aborted due to a resin-tray leak, see
the section Recover from Resin-Tray Leak
1. Fully post-process the build parts, as fully cured parts
can be disposed of in regular trash. Please see the
Processing Guide for more information.
2. Check the resin tray for partially cured material. If the
part did not finish building, it is possible that partially cured
bits fell into the tray. If you suspect there is partially cured
material in the tray, Run a Resin-Tray Cleaning
3D Systems, Inc.
for
below.
Post-
.
115 p/n 42-D116, Rev. K