3D Systems FIGURE 4 MODULAR User Manual page 145

1. If uncured material remains within the tray, repeat steps
6-9.
2. If uncured material remains on the outer edges of the
resin tray:
a. Wipe clean with a lint-free paper towel soaked with
>90% alcohol (~15mL). Discard used paper towels and
gloves according to all government regulations.
b. Gently dry resin tray with dry, compressed air using an
air gun attachment at 30 psi, or allow tray to air dry for
one hour.
1. Inspect the resin tray to ensure no uncured material
and/or foreign objects remain.
1. Be sure to discard all paper towels/wipes used throughout this procedure according to all government regulations.
The resin tray can now be stored in the Resin-Tray Garage or be reinstalled in a printer, according to the section Resin Tray
Material Cross Usage.
Note: Even though you have cleaned the tray of all material in this procedure, it is still necessary to store the
resin tray via one of the methods below to ensure protection of the bottom and top of the resin tray.
3D Systems, Inc. 141 p/n 42-D116, Rev. K