3D Systems FIGURE 4 MODULAR User Manual page 72

6.1.1.1.4 Printer Info Card
3D Systems, Inc.
Name - This is the name that you assigned to
A
the Printer. The default name is in the following
format: Module.[last 4 digits of printer SN]
To change the name: tap the
icon at the right.
Firmware - This is the firmware version that is
B
running on the Printer.
To view more information: tap the
icon at the right.
IP Address - The IP address of the Printer
C
To change network settings for printer: tap the
icon at the right. Please see the section
Network Settings
Locate Printer Button - Tap this button to locate
D
the Printer. Upon tapping the button, the light
stack on top of the Printer starts blinking for one
minute to assist in locating the unit. This can be
very useful in an environment with many Printers.
Delete - Tap this button to remove a Printer from
E
the Controller.
Enable Toggle - Tap this on-screen switch to
F
toggle the Printer between the "enabled" and
"disabled" states. If the unit is enabled, it will
get assigned jobs from the print queue. If it is
disabled, it will not get assigned jobs from the
print queue. This toggle switch is disabled during
printing. Please see the section
for more information.
68
Printer
for more information.
Print Job Overview
p/n 42-D116, Rev. K