Printer Message Glossary - 3D Systems FIGURE 4 MODULAR User Manual

9

PRINTER MESSAGE GLOSSARY

The following table lists error messages you may encounter on the Controller and Printer screens during usage of the Figure 4
Modular System, along with how to clear the error and resume normal operation.
Tip: If you wish to print this page, please print in 75% scale and in landscape orientation for best results.
CAUTION: Unless the troubleshooting steps in this section require the printer to be powered on, shut down
the printer you are working on before troubleshooting.
# ERROR TEXT ON
PRINTER DISPLAY
34-01-1
Paused: [job name]
00
Close door to
resume print. Job will
automatically cancel in
X:XX minutes...
or
Please close door.
Close door to mark
printer as ready.
34-01-1
Temperature Warning
02
Printer temperature is
out of range 18-28°C.
34-01-1 Replace Print Platform
05 Please replace print
platform and mark
printer as ready.
34-01-1 Missing Resin Tray
14 Please replace resin
tray and mark printer
as ready.
34-01-1 Missing Catch Tray
16 Please replace catch
tray and mark printer
as ready.
34-01-1 Resin Tray
15 Untensioned Please
check machine air
pressure and tension
the tray to continue.
3D Systems, Inc.
ERROR TEXT ON
CONTROLLER
Paused: Door is open
Machine will resume
printing when the door
is closed. Or, the job will
abort after the max pause
time.
or
Top door open on [printer
name]. Close door to mark
printer as ready.
Temperature Warning on
[printer name] Printer
temperature is out of
range. Optimal printing
temp. is 18-28°C. Please
adjust facility temperature
to continue.
Print platform missing
in [printer name] Please
replace print platform and
mark printer as ready to
continue printing.
Missing Resin Tray in
[printer name] Resin Tray
on [printer name] is
missing. Please replace
resin tray and mark
printer as ready.
Missing Catch Tray in
[printer name] Catch Tray
on [printer name] is
missing. Please replace
catch tray and mark
printer as ready.
Button: Dismiss
Tray Untensioned in
[printer name] Please
check air pressure and
use button to tension the
tray.
Button: Dismiss
168
STACK LIGHT HOW TO CLEAR
STATE
Flashing yellow Close the front, upper door on the affected
printer and tap the "resume" button.
Flashing red Printer cannot be marked as "ready" until
temperature sensor reads 18-28°C.
Flashing yellow Install a print platform.
Flashing yellow Install a resin tray.
Flashing yellow Install a catch tray.
Flashing yellow Press button to tension resin tray.
p/n 42-D116, Rev. K