3D Systems FIGURE 4 MODULAR User Manual page 148

1. Wipe down the platform with a lint-free paper towel or
nonabrasive cloth.
1. Inspect the platform, particularly the holes on the flat
surface, to ensure no partially cured material remains. If
you find material or partially cured bits on the platform
at this point, follow the steps in this section again on the
problem areas.
2. Allow the platform sufficient time to dry. Use compressed
air to speed up this process, if desired.
Your print platform is now clean and ready to be reused.
Special Consideration for Elastomeric Materials
For cleaning print platforms that run elastomeric materials such as ELAST-BLK 10, your printer package includes a Wire Brush.
The following instructions demonstrate how to use this brush.
1. Use the Platform Scraper to remove as much partially
cured material as you can.
3D Systems, Inc. 144 p/n 42-D116, Rev. K