Displaying And Maintaining Rip; Rip Configuration Examples; Configuring Rip Version - 3Com S7906E Configuration Manual

To do...
Specify a RIP neighbor
Enter interface view
Enable BFD on the RIP
interface
Unidirectional detection in BFD echo packet mode only works for RIP neighbors that are directly
connected, namely, one hop away from each other.
Using the undo peer command does not remove the neighbor relationship at once and therefore
cannot bring down the BFD session at once.

Displaying and Maintaining RIP

To do...
Display RIP current status and
configuration information
Display all active routes in RIP
database
Display RIP interface
information
Display routing information
about a specified RIP process
Reset a RIP process
Clear the statistics of a RIP
process

RIP Configuration Examples

Configuring RIP Version

Network requirements
As shown in Figure
Use the command...
peer ip-address
interface interface-type
interface-number
rip bfd enable
Use the command...
display rip [ process-id |
vpn-instance
vpn-instance-name ]
display rip process-id
database
display rip process-id
interface [ interface-type
interface-number ]
display rip process-id route
[ ip-address { mask |
mask-length } | peer ip-address
| statistics ]
reset rip process-id process
reset rip process-id statistics
1-4, enable RIPv2 on all interfaces on Switch A and Switch B.
1-18
Remarks
Required
By default, RIP does not
unicast updates to any peer.
—
Required
Disabled by default
Remarks
Available in any view
Available in user view