To do...
Display the GR status of the
specified OSPFv3 process
OSPFv3 Configuration Examples
Configuring OSPFv3 Areas
Network requirements
In the following figure, all switches run OSPFv3. The AS is split into three areas, in which, Switch B and
Switch C act as ABRs to forward routing information between areas.
It is required to configure Area 2 as a stub area to reduce LSAs in the area without affecting route
reachability.
Figure 1-2 Network diagram for OSPFv3 area configuration
Configuration procedure
1)
Configure IPv6 addresses for interfaces (omitted)
2)
Configure OSPFv3 basic functions
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] ospfv3
[SwitchA-ospfv3-1] router-id 1.1.1.1
[SwitchA-ospfv3-1] quit
[SwitchA] interface vlan-interface 300
[SwitchA-Vlan-interface300] ospfv3 1 area 1
[SwitchA-Vlan-interface300] quit
[SwitchA] interface vlan-interface 200
[SwitchA-Vlan-interface200] ospfv3 1 area 1
[SwitchA-Vlan-interface200] quit
Use the command...
display ospfv3 [ process-id ] graceful-restart
status
1-17
Remarks