3Com S7906E Configuration Manual page 604

To do...
Enter system view
Enable a RIP process and
enter RIP view
Enable RIP on the interface
attached to the specified
network
If you make some RIP configurations in interface view before enabling RIP, those configurations
will take effect after RIP is enabled.
RIP runs only on the interfaces residing on the specified networks. Therefore, you need to specify
the network after enabling RIP to validate RIP on a specific interface.
You can enable RIP on all interfaces using the command network 0.0.0.0.
If a physical interface is attached to multiple networks, you cannot advertise these networks in
different RIP processes.
Configuring the interface behavior
Follow these steps to configure the interface behavior:
To do...
Enter system view
Enter RIP view
Disable an or all interfaces from
sending routing updates (the
interfaces can still receive
updates)
Return to system view
Enter interface view
Enable the interface to receive
RIP messages
Enable the interface to send
RIP messages
Configuring a RIP version
You can configure a RIP version in RIP or interface view.
Use the command...
system-view
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
network network-address
Use the command...
system-view
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
silent-interface
{ interface-type
interface-number | all }
quit
interface interface-type
interface-number
rip input
rip output
1-6
Remarks
––
Required
Not enabled by default
Required
Disabled by default
Remarks
––
––
Optional
All interfaces can send routing
updates by default.
—
—
Optional
Enabled by default
Optional
Enabled by default