Configuring Layer 3 Remote Port Mirroring; Layer 3 Remote Port Mirroring Configuration Task List - 3Com S7906E Configuration Manual

To do...
Enter system view
Enter the interface view of the
monitor port
Assign the
port to the
probe VLAN
For more information about the port access vlan command, the port trunk permit vlan command,
and the port hybrid vlan command, see VLAN Commands in the Access Volume.

Configuring Layer 3 Remote Port Mirroring

Layer 3 Remote Port Mirroring Configuration Task List

To configure Layer 3 remote port mirroring, you need to create a local port mirroring group on the
source device as well as on the destination device, and configure mirroring port and the monitor port for
each mirroring group. The source and destination devices are connected by a tunnel.
On the source device, you need to configure the port you want to monitor as the mirroring port, and
configure the tunnel interface as the monitor port.
On the destination device, you need to configure the physical port corresponding to the tunnel
interface as the mirroring port and configure the port that connects the data monitoring device as
the monitor port.
Complete these tasks to configure Layer 3 remote port mirroring:
Configuring the source
device
Configuring the
destination device
system-view
interface interface-type interface-number
For an access
port access vlan vlan-id
port
For a trunk port port trunk permit vlan vlan-id
For a hybrid port hybrid vlan vlan-id { tagged |
port untagged }
Task
Configuring Local Mirroring Groups
Configuring Mirroring Ports for a Local
Mirroring Group
Configuring the Monitor Port for a Local
Mirroring Group
Configuring Local Mirroring Groups
Configuring Mirroring Ports for a Local
Mirroring Group
Configuring the Monitor Port for a Local
Mirroring Group
Use the command...
1-12
Remarks
—
—
Required
Use one of the
commands
Remarks
Required
Required
Required
Required
Required
Required