Specifying The Lsa Generation Interval; Disabling Interfaces From Sending Ospf Packets - 3Com S7906E Configuration Manual

Specifying the LSA Generation Interval

With this feature configured, you can protect network resources and routers from being over consumed
due to frequent network changes.
Follow these steps to configure the LSA generation interval:
To do...
Enter system view
Enter OSPF view
Configure the LSA
generation interval
With this command configured, when network changes are not frequent, LSAs are generated at the
minimum-interval. If network changes become frequent, LSA generation interval is incremented by
incremental-interval•2n-2 (n is the number of generation times) each time a generation occurs, up to
the maximum-interval.

Disabling Interfaces from Sending OSPF Packets

Follow these steps to disable interfaces from sending routing information:
To do...
Enter system view
Enter OSPF view
Disable interfaces from
sending OSPF packets
Use the command...
system-view
ospf [ process-id | router-id
router-id | vpn-instance
instance-name ] *
lsa-generation-interval
maximum-interval [ initial-interval
[ incremental-interval ] ]
Use the command...
system-view
ospf [ process-id | router-id
router-id | vpn-instance
instance-name ] *
silent-interface { interface-type
interface-number | all }
1-39
Remarks
—
Required
Optional
By default, the maximum interval
is 5 seconds, the minimum
interval is 0 milliseconds and the
incremental interval is 5000
milliseconds.
Remarks
—
—
Optional
Not disabled by default