Displaying And Maintaining Lldp; Lldp Configuration Examples; Basic Lldp Configuration Example - 3Com S7906E Configuration Manual

To do...
Quit to system view
Set the interval to send LLDP
traps

Displaying and Maintaining LLDP

To do...
Display the global LLDP
information or the information
contained in the LLDP TLVs to
be sent through a port
Display the information
contained in the LLDP TLVs
sent from neighboring devices
Display LLDP statistics
Display LLDP status of a port
Display types of advertisable
optional LLDP TLVs

LLDP Configuration Examples

Basic LLDP Configuration Example

Network requirements
As shown in Figure
Switch B are connected to GigabitEthernet 2/0/1 and GigabitEthernet 2/0/2 of Switch A.
Enable LLDP on the ports of Switch A and Switch B to monitor the link between Switch A and Switch B
and the link between Switch A and the MED device on the NMS.
Figure 1-4 Network diagram for basic LLDP configuration
NMS
quit
lldp timer notification-interval
interval
display lldp local-information
[ global | interface interface-type
interface-number ]
display lldp neighbor-information
[ brief | interface interface-type
interface-number [ brief ] | list
[ system-name system-name ] ]
display lldp statistics [ global |
interface interface-type
interface-number ]
display lldp status [ interface
interface-type interface-number ]
display lldp tlv-config [ interface
interface-type interface-number ]
1-4, the NMS and Switch A are located in the same Ethernet. An MED device and
MED
GE2/0/1
GE2/0/2
Switch A
Use the command...
Use the command...
GE2/0/1
Switch B
1-13
Remarks
—
Optional
5 seconds by default
Remarks
Available in any view
Available in any view
Available in any view
Available in any view
Available in any view