Protocols And Standards; Tunneling Configuration Task List - 3Com S7906E Configuration Manual

Passenger protocol: Protocol that the payload packet uses, IPX in the example.
Encapsulation or carrier protocol: Protocol used to encapsulate the payload packet, that is, GRE.
Delivery or transport protocol: Protocol used to encapsulate the GRE packet and then forward the
packet to the other end of the tunnel, IP in this example.
Depending on the transport protocol, two tunnel modes are present: GRE over IPv4 and GRE over
IPv6.
Decapsulation process
Decapsulation is the reverse process of encapsulation:
1) Upon receiving an IP packet from the tunnel interface, Router B checks the destination address.
2) If the destination is itself, Router B strips off the IP header of the packet and submits the resulting
packet to the GRE protocol.
3) The GRE protocol checks the key, checksum and sequence number in the packet, and then strips
off the GRE header and submits the payload to the X protocol for forwarding.
Encapsulation and decapsulation processes on both ends of the GRE tunnel and the resulting increase
in data volumes will degrade the forwarding efficiency for the GRE-enabled device to some extent.

Protocols and Standards

RFC 1853: IP in IP Tunneling
RFC 2473: Generic Packet Tunneling in IPv6 Specification
RFC 2893: Transition Mechanisms for IPv6 Hosts and Routers
RFC 3056: Connection of IPv6 Domains via IPv4 Clouds
RFC 4214: Intra-Site Automatic Tunnel Addressing Protocol (ISATAP)

Tunneling Configuration Task List

Complete the following tasks to configure the tunneling feature:
Configuring a Tunnel Interface
Configuring an
IPv6 over IPv4
tunnel
Configuring an IPv4 over IPv4 Tunnel
Configuring an IPv4 over IPv6 Tunnel
Configuring an IPv6 over IPv6 Tunnel
Configuring a GRE over IPv4 Tunnel
Configuring a GRE over IPv6 Tunnel
Task
Configuring an IPv6 Manual Tunnel
Configuring a 6to4 Tunnel
Configuring an ISATAP Tunnel
1-8
Remarks
Required
Optional
Use one as needed.
Optional
Optional
Optional
Optional
Optional