Configuring The Link Type Of An Olt Port; Enabling Layer-2 Communication Between The Onus Attached To An Olt Port - 3Com S7906E Configuration Manual

To do...
Enter system view
Enter OLT port view
Enable grant filtering on the
OLT port

Configuring the Link Type of an OLT Port

You can configure an OLT port as a hybrid port, and assign it to the specified VLANs in tagged mode or
untagged mode.
Follow these steps to configure the link type of an OLT port:
To do...
Enter system view
Enter OLT port view
Configure the OLT port as a
hybrid port
Assign the port to the specified
VLANs in tagged mode or
untagged mode
Configure the default VLAN of
the OLT port
The VLAN(s) that you assign an OLT port to must already exist.

Enabling Layer-2 Communication Between the ONUs Attached to an OLT Port

By default, Layer-2 communication is disabled between the ONUs attached to an OLT port, that is, the
ONUs attached to an OLT port cannot communicate with each other at Layer 2. To make the devices or
users connected to the ONUs attached to the same OLT port communicate, you can enable this
function.
Follow these steps to enable Layer-2 communication between the ONUs attached to an OLT port:
To do...
Enter system view
Enter OLT port view
Enable Layer-2 communication
between the ONUs attached to
the OLT port
Use the command...
system-view
interface olt interface-number
grant-filtering enable
Use the command...
system-view
interface olt interface-number
port link-type hybrid
port hybrid vlan vlan-id-list
{ tagged | untagged }
port hybrid pvid vlan vlan-id
Use the command...
system-view
interface olt interface-number
sme enable
2-5
Remarks
—
—
Optional
Enabled by default
Remarks
—
—
Optional
Required
By default, an OLT port belongs
to only VLAN 1 and forwards
packets of VLAN 1 tagged.
Optional
VLAN 1 by default
Remarks
—
—
Optional
Disabled by default