3Com S7906E Configuration Manual page 855

[SwitchB-ripng-1] filter-policy 2000 export
# Display routing tables of Switch B and Switch A.
[SwitchB] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::20F:E2FF:FE23:82F5
Dest 1::/64,
via FE80::20F:E2FF:FE23:82F5, cost
Dest 2::/64,
via FE80::20F:E2FF:FE23:82F5, cost
Peer FE80::20F:E2FF:FE00:100
Dest 4::/64,
via FE80::20F:E2FF:FE00:100, cost
Dest 5::/64,
via FE80::20F:E2FF:FE00:100, cost
[SwitchA] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::20F:E2FF:FE00:1235
Dest 1::/64,
via FE80::20F:E2FF:FE00:1235, cost
Dest 4::/64,
via FE80::20F:E2FF:FE00:1235, cost
Dest 5::/64,
via FE80::20F:E2FF:FE00:1235, cost
Configuring RIPng Route Redistribution
Network requirements
Two RIPng processes are running on Switch B, which communicates with Switch A through RIPng
100 and with Switch C through RIPng 200.
Configure route redistribution on Switch B, letting the two RIPng processes redistribute routes from
each other. Set the default cost of redistributed routes from RIPng 200 to 3.
Figure 1-5 Network diagram for RIPng route redistribution configuration
on Vlan-interface100
1, tag 0, A, 2 Sec
1, tag 0, A, 2 Sec
on Vlan-interface200
1, tag 0, A, 5 Sec
1, tag 0, A, 5 Sec
on Vlan-interface100
1, tag 0, A, 2 Sec
2, tag 0, A, 2 Sec
2, tag 0, A, 2 Sec
1-12