Sa Message Filtering Configuration - 3Com S7906E Configuration Manual

SA Message Filtering Configuration

Network requirements
Three PIM-SM domains exist in the network, and OSPF runs within and among the domains to
provide unicast routing.
Configure respective Loopback 0 of Switch A, Switch C and Switch D as a C-BSR and C-RP in the
respective PIM-SM domain.
Set up an MSDP peering relationship between Switch A and Switch C and between Switch C and
Switch D.
Source 1 sends multicast data to multicast groups 225.1.1.0/30 and 226.1.1.0/30, and Source 2
sends multicast data to multicast group 227.1.1.0/30.
Configure SA message filtering rules so that receivers Host A and Host B can receive only the
multicast data addressed to multicast groups 225.1.1.0/30 and 226.1.1.0/30, while Host can
receive only the multicast data addressed to multicast groups 226.1.1.0/30 and 227.1.1.0/30.
Network diagram
Figure 1-8 Network diagram for SA message filtering configuration
Device Interface
Source 1 —
Source 2 —
Switch A Vlan-int100
Vlan-int102
Vlan-int101
Loop0
Switch B Vlan-int200
Vlan-int102
Vlan-int103
Configuration Procedure
1) Configure IP addresses and unicast routing
IP address Device
10.110.3.100/24 Switch C
10.110.6.100/24
10.110.1.1/24
10.110.2.1/24
192.168.1.1/24
1.1.1.1/32 Switch D
10.110.3.1/24
10.110.2.2/24
192.168.2.1/24
1-30
Interface IP address
Vlan-int300 10.110.4.1/24
Vlan-int104 10.110.5.1/24
Vlan-int101 192.168.1.2/24
Vlan-int103 192.168.2.2/24
Loop0 2.2.2.2/32
Vlan-int400 10.110.6.1/24
Vlan-int500 10.110.7.1/24
Vlan-int104 10.110.5.2/24
Loop0 3.3.3.3/32