Configuring Is-Is Basic Functions; Enabling Is-Is; Configuring The Is Level And Circuit Level - 3Com S7906E Configuration Manual

Configuring IS-IS
Authentication
Configuring
System ID to Host
Name Mappings
Configuring IS-IS GR
Enabling the Logging of Neighbor State Changes
Enabling IS-IS SNMP Trap
Binding an IS-IS Process with MIBs
Configuring BFD for IS-IS

Configuring IS-IS Basic Functions

Configuration Prerequisites
Before the configuration, accomplish the following tasks:
Configure the link layer protocol.
Configure an IP address for each interface, and make sure all neighboring nodes are reachable to
each other at the network layer.

Enabling IS-IS

Follow these steps to enable IS-IS:
To do...
Enter system view
Enable the IS-IS routing
process and enter its view
Assign a network entity title
(NET)
Return to system view
Enter interface view
Enable an IS-IS process on the
interface

Configuring the IS Level and Circuit Level

If only one area is available, it is recommended that:
Task
Configuring Neighbor Relationship Authentication
Configuring Area Authentication
Configuring Routing Domain Authentication
Configuring a Static System ID to Host Name Mapping
Configuring Dynamic System ID to Host Name Mapping
Use the command...
system-view
isis [ process-id ]
[ vpn-instance
vpn-instance-name ]
network-entity net
quit
interface interface-type
interface-number
isis enable [ process-id ]
1-17
Remarks
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Remarks
––
Required
Not enabled by default
Required
Not assigned by default
––
––
Required
Disabled by default