To do...
Display OSPF ASBR
summarization information
Reset OSPF counters
Reset an OSPF process
Re-enable OSPF route
redistribution
OSPF Configuration Examples
These examples only cover commands for OSPF configuration.
Configuring OSPF Basic Functions
Network requirements
As shown in the following figure, all switches run OSPF. The AS is split into three areas, in which,
Switch A and Switch B act as ABRs to forward routing information between areas.
After configuration, all switches can learn routes to every network segment in the AS.
Figure 1-21 Network diagram for OSPF basic configuration
Configuration procedure
1)
Configure IP addresses for interfaces (omitted)
2)
Configure OSPF basic functions
# Configure Switch A.
Use the command...
display ospf [ process-id ] asbr-summary
[ ip-address { mask | mask-length } ]
reset ospf [ process-id ] counters [ neighbor
[ interface-type interface-number ]
[ router-id ] ]
reset ospf [ process-id ] process
[ graceful-restart ]
reset ospf [ process-id ] redistribution
1-49
Remarks
Available in user
view