Performing Basic Lldp Configuration; Enabling Lldp; Setting Lldp Operating Mode - 3Com S7906E Configuration Manual

Configuring CDP Compatibility
Configuring LLDP Trapping
LLDP-related configurations made in Ethernet interface view takes effect only on the current port, and
those made in port group view takes effect on all ports in the current port group.

Performing Basic LLDP Configuration

Enabling LLDP

To make LLDP take effect on certain ports, you need to enable LLDP both globally and on these ports.
Follow these steps to enable LLDP:
To do...
Enter system view
Enable LLDP globally
Enter
Ethernet
interface
view or port
group view
Enable LLDP

Setting LLDP Operating Mode

LLDP can operate in one of the following modes.
TxRx mode. A port in this mode sends and receives LLDP frames.
Tx mode. A port in this mode only sends LLDP frames.
Rx mode. A port in this mode only receives LLDP frames.
Disable mode. A port in this mode does not send or receive LLDP frames.
Follow these steps to set LLDP operating mode:
Task
Configuring the Management Address and Its Encoding Format
Setting Other LLDP Parameters
Setting an Encapsulation Format for LLDPDUs
system-view
lldp enable
Enter Ethernet interface interface-type
interface view interface-number
Enter port port-group manual
group view port-group-name
lldp enable
Use the command...
1-7
Remarks
Optional
Optional
Optional
Optional
Optional
Remarks
—
Required
By default, LLDP is disabled
globally.
Required
Use either command.
Optional
By default, LLDP is enabled on
a port.