3Com S7906E Configuration Manual page 452

Dynamic domain name resolution and the domain name suffix are configured on the Switch that serves
as a DNS client, and thus the Switch can use domain name host to access the host with the domain
name host.com and the IPv6 address 1::1/64.
Figure 2-2 Network diagram of dynamic domain name resolution
Configuration procedure
Before performing the following configuration, make sure that the Switch and the host are
accessible to each another via available routes, and the IPv6 addresses of the interfaces are
configured as shown
This configuration may vary with different DNS servers. The following configuration is performed on
a PC running Windows server 2003. Make sure that the DNS server supports the IPv6 DNS
function so that the server can process IPv6 DNS packets, and the interfaces of the DNS server
can forward IPv6 packets.
1) Configure the DNS server
# Enter the DNS server configuration page.
Select Start > Programs > Administrative Tools > DNS.
# Create zone com.
Figure 2-2.
2-4