Ftp Client Configuration Example (Distributed Device) - 3Com S7906E Configuration Manual

Terminate the connection to the FTP
server without exiting FTP client view
Terminate the connection to the FTP
server without exiting FTP client view
Terminate the connection to the FTP
server and return to user view
Terminate the connection to the FTP
server and return to user view

FTP Client Configuration Example (Distributed Device)

Network requirements
As shown in
are 10.2.1.1/16 and 10.1.1.1/16 respectively. An available route exists between Device and PC.
Device downloads a startup file from PC for device upgrade, and uploads the configuration file to
PC for backup.
On PC, an FTP user account has been created for the FTP client, with the username being abc
and the password being pwd.
Figure 1-2 Network diagram for FTPing a startup file from an FTP server
Configuration procedure
If the available memory space of the device is not enough, use the fixdisk command to clear the
memory or use the delete /unreserved file-url command to delete the files not in use and then perform
the following operations.
# Log in to the server through FTP.
<Sysname> ftp 10.1.1.1
Trying 10.1.1.1 ...
Connected to 10.1.1.1.
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
To do...
Figure 1-2, use Device as an FTP client and PC as the FTP server. Their IP addresses
Use the command...
disconnect
close
bye
quit
1-7
Remarks
Optional
Equal to the close
command.
Optional
Equal to the disconnect
command.
Optional
Optional
Available in FTP client view,
equal to the bye command.