Displaying And Debugging Rip - 3Com Switch 4500 26-Port Configuration Manual

Configuring RIP to Filter the Received Routes
Table 119 Configuring RIP to Filter the Received Routes
Operation
Filter the received routing information
distributed by the specified address
Cancel filtering of the received routing
information distributed by the specified
address
Filter the received global routing information filter-policy {acl_number |
Cancel filtering of the received global routing
information
Configuring RIP to Filter the Distributed Routes
Table 120 Configuring RIP to Filter the Distributed Routes
Operation
Configure RIP to filter the
distributed routing
information
Cancel the filtering of the
routing information
By default, RIP will not filter the received and distributed routing information.
■
■
■
Displaying and After configuring RIP, enter the
Debugging RIP configuration, and to verify the effect of the configuration. Enter the
command in User View to debug the RIP module. Enter the
View to reset the system configuration parameters of RIP.
Table 121 Displaying and Debugging RIP
Operation
Display the current RIP running state and
configuration information
Enable the RIP debugging information
Disable the RIP debugging information
Command
filter-policy { acl_number | ip-prefix
ip_prefix_name | route-policy route_policy_name
} export [ routing_protocol ]
undo filter-policy { acl_number | ip-prefix
ip_prefix-name | route-policy route_policy_name
} export [ routing_protocol ]
The
filter-policy import
neighbors, and the routes that cannot pass the filter will not be added to the
routing table, and will not be advertised to the neighbors.
The
filter-policy export
including routes imported by using the
routes learned from the neighbors.
If the
filter-policy export
filtered, then all the routes imported by the
transmitted RIP routes will be filtered.
Command
filter-policy gateway
ip_prefix_name import
undo filter-policy gateway
ip_prefix_name [ gateway
ip-prefix-name ] | route-policy
route-policy-name } import
ip-prefix ip_prefix_name [
gateway ip-prefix-name ] |
route-policy route-policy-name }
import
undo filter-policy { acl_number |
ip-prefix ip_prefix_name } import
command filters the RIP routes received from its
command filters all the advertised routes,
import-route
command does not specify which route is to be
import-route
command in any view to display the RIP
display
Command
display rip
debugging rip packet
undo debugging rip packet
RIP 119
command, and RIP
command and the
debugging
command in RIP
reset