Displaying And Maintaining Rip Configuration; Rip Configuration Example - 3Com E4500-24 Cli Configuration Manual

Configuring RIP to unicast RIP packets
Follow these steps to configure RIP to unicast RIP packets:
To do...
Enter system view
Enter RIP view
Configure RIP to
unicast RIP packets

Displaying and Maintaining RIP Configuration

Display the current RIP running status and
configuration information
Display RIP interface information
Display RIP routing information
Reset the system configuration related to RIP

RIP Configuration Example

Network requirements
A small-sized company requires that any two nodes in its small office network communicate with each
other, and that the network devices automatically adapt themselves to any topology change so as to
reduce the work of manual maintenance.
In this case, RIP can implement communication between any two nodes.
Network diagram
According to the network requirements, the network topology is designed as shown in
Figure 3-1 Network diagram for RIP configuration
Device Interface
Switch A Vlan-int1
Vlan-int2
Use the command...
system-view
rip
peer ip-address
To do...
IP address
110.11.2.1/24
155.10.1.1/24
—
—
Required
When RIP runs on the link that does not support
broadcast or multicast, you must configure RIP to
unicast RIP packets.
Use the command...
display rip
display rip interface
display rip routing
reset
Device Interface
Switch B Vlan-int1
Vlan-int3
3-10
Remarks
Remarks
Available in any
view
Available in RIP
view
Figure 3-1.
IP address
110.11.2.2/24
196.38.165.1/24