Configuring Global Alarms - 3Com S7906E Configuration Manual

Configure the
statistics
sampling
function
Configure the
alarm monitoring
function

Configuring Global Alarms

Follow these steps to configure global alarms:
To do...
Enter system view
Enter FTTH view
Enable the software error alarm
function
Enable the bit error rate alarm
function
Configure the monitor direction
and threshold for bit error rate
alarms
Enable the port bit error rate
alarm function
To do...
Enable the statistics
sampling function
Configure the statistics
sampling interval
Enable alarm monitoring
function for the system
Configure the alarm
monitor period
Use the command...
system-view
ftth
alarm software-error enable
alarm bit-error-rate enable
alarm bit-error-rate
{ direction { uplink | downlink
| up-down-link} | threshold
threshold }*
alarm port bit-error-rate
enable
Use the command...
sample enable
timer sample seconds
monitor enable
timer monitor seconds
—
—
Optional
The system generates a
software error alarm when a
signal error, Data Access (DA)
error, or memory allocation
failure occurs.
By default, this function is
enabled.
Optional
When the total number of error
bits or bit error rate of the data
transferred between the OLT
and ONUs exceeds the alarm
threshold, a bit error rate alarm
occurs.
By default, this function is
enabled.
Optional
By default, the monitor direction
is up-down-link, and the alarm
threshold of bit error rate is 10
(the unit is 10
Optional
When both the total number of
error bits and bit error rate of
the data transferred between
the OLT and ONUs exceed the
alarm thresholds, a port bit
error rate alarm occurs.
By default, this function is
enabled.
5-2
Remarks
Optional
Enabled by default
Optional
4 seconds by default
Optional
Enabled by default
Optional
80 seconds by default
Remarks
-9
).