Configuring Ospfv3 Route Redistribution - 3Com S7906E Configuration Manual

To do...
Configure a priority for
OSPFv3

Configuring OSPFv3 Route Redistribution

Follow these steps to configure OSPFv3 route redistribution:
To do...
Enter system view
Enter OSPFv3 view
Specify a default cost for
redistributed routes
Redistribute routes from
another protocol, or another
OSPFv3 process
Inject a default route
Filter redistributed routes
Executing the import-route or default-route-advertise command on a router makes it become an
ASBR,.
You can only inject and advertise a default route using the default-route-advertise command.
Since OSPFv3 is a link state routing protocol, it cannot directly filter LSAs to be advertised.
Therefore, you need to filter redistributed routes first, and thus only routes that are not filtered out
can be advertised in LSAs into the routing domain.
Use of the filter-policy export command filters routes redistributed with the import-route
command. If the import-route command is not configured, executing the filter-policy export
command does not take effect.
Use the command...
preference [ ase ]
[ route-policy
route-policy-name ]
preference
Use the command...
system-view
ospfv3 [ process-id ]
default cost value
import-route { isisv6 process-id | ospfv3
process-id | ripng process-id | bgp4+
[ allow-ibgp ] | direct | static } [ cost value
| type type | route-policy
route-policy-name ] *
default-route-advertise [ always | cost
cost | type type | route-policy
route-policy-name ] *
filter-policy { acl6-number | ipv6-prefix
ipv6-prefix-name } export [ isisv6
process-id | ospfv3 process-id | ripng
process-id | bgp4+ | direct | static ]
1-11
Remarks
Optional
By default, the priority of OSPFv3
internal routes is 10, and priority of
OSPFv3 external routes is 150.
Remarks
—
—
Optional
Defaults to 1
Required
Not configured by
default
Optional
Not injected by
default
Optional
Not configured by
default