Disable Interfaces From Sending Ospfv3 Packets; Enable The Logging Of Neighbor State Changes - 3Com S7906E Configuration Manual

To do...
Ignore MTU check for DD
packets

Disable Interfaces from Sending OSPFv3 Packets

Follow these steps to disable interfaces from sending OSPFv3 packets:
To do...
Enter system view
Enter OSPFv3 view
Disable interfaces from sending
OSPFv3 packets
Multiple OSPFv3 processes can disable the same interface from sending OSPFv3 packets. Using
the silent-interface command disables only the interfaces associated with the current process.
After an OSPF interface is set to silent, direct routes of the interface can still be advertised in
Intra-Area-Prefix-LSAs via other interfaces, but other OSPFv3 packets cannot be advertised.
Therefore, no neighboring relationship can be established on the interface. This feature can
enhance the adaptability of OSPFv3 networking.

Enable the Logging of Neighbor State Changes

Follow these steps to enable the logging of neighbor state changes:
To do...
Enter system view
Enter OSPFv3 view
Enable the logging of neighbor
state changes
Use the command...
ospfv3 mtu-ignore [ instance
instance-id ]
Use the command...
system-view
ospfv3 [ process-id ]
silent-interface
{ interface-type
interface-number | all }
Use the command...
system-view
ospfv3 [ process-id ]
log-peer-change
1-14
Remarks
Required
Not ignored by default
Remarks
—
—
Required
Not disabled by default
Remarks
—
—
Required
Enabled by default