Configuring Dhcp Snooping To Support Option 82; Prerequisites - 3Com S7906E Configuration Manual

You need to specify the ports connected to the authorized DHCP servers as trusted to ensure that
DHCP clients can obtain valid IP addresses. The trusted port and the port connected to the DHCP
client must be in the same VLAN.
Currently, you can specify Layer 2 Ethernet interfaces and Layer 2 aggregate interfaces as trusted
ports. For details about aggregate interfaces, refer to Link Aggregation Configuration in the Access
Volume.
If a Layer 2 Ethernet interface is added to an aggregation group, the DHCP snooping configuration
of the interface will not take effect. After the interface quits the aggregation group, the configuration
will be effective.
Configuring both the DHCP snooping and selective QinQ function on the switch is not
recommended because it may result in malfunction of DHCP snooping.

Configuring DHCP Snooping to Support Option 82

Prerequisites

You need to enable the DHCP snooping function before configuring DHCP snooping to support Option
82.
Configuring DHCP Snooping to Support Option 82
Follow these steps to configure DHCP snooping to support Option 82:
To do...
Enter system view
Enter interface view
Enable DHCP snooping to support
Option 82
Configure the handling strategy for
requesting messages containing
Option 82
Use the command...
system-view
interface interface-type
interface-number
dhcp-snooping information enable
dhcp-snooping information
strategy { drop | keep | replace }
5-5
Remarks
—
—
Required
Disabled by default.
Optional
replace by default.