Configuration Procedure - 3Com S7906E Configuration Manual

Configuration Procedure

Follow these steps to configure an IPv6 manual tunnel:
To do...
Enter system view
Enable IPv6
Enter tunnel interface view
Configure an
IPv6 address
for the tunnel
interface
Specify the IPv6 manual tunnel
mode
Configure a source address or
interface for the tunnel
Configure a destination
address for the tunnel
Use the command...
system-view
ipv6
interface tunnel number
ipv6 address { ipv6-address
Configure a
prefix-length |
global unicast
ipv6-address/prefix-length }
IPv6 address
ipv6 address
or a site-local
ipv6-address/prefix-length
address
eui-64
ipv6 address auto link-local
Configure a
link-local IPv6
ipv6 address ipv6-address
address
link-local
tunnel-protocol ipv6-ipv4
source { ip-address |
interface-type
interface-number }
destination ip-address
—
Required
By default, the IPv6 packet
forwarding function is disabled.
—
Required
Use either command.
By default, no IPv6 global
unicast address or site-local
address is configured for the
tunnel interface.
Optional
By default, a link-local address
will automatically be created
when an IPv6 global unicast
address or site-local address is
configured.
Required
By default, the tunnel is a GRE
over IPv4 tunnel. The same
tunnel mode should be
configured at both ends of the
tunnel. Otherwise, packet
delivery will fail.
Required
By default, no source address or
interface is configured for the
tunnel.
Required
By default, no destination
address is configured for the
tunnel.
1-10
Remarks