Assigning A Hybrid Port To A Vlan - 3Com S7906E Configuration Manual

To change the link type of a port from trunk to hybrid or vice versa, you must set the link type to
access first.
After configuring the default VLAN for a trunk port, you must use the port trunk permit vlan
command to configure the trunk port to allow packets from the default VLAN to pass through, so
that the egress port can forward packets from the default VLAN.
After you configure a command on a Layer 2 aggregate interface, the system starts applying the
configuration to the aggregate interface and its aggregation member ports. If the system fails to do
that on the aggregate interface, it stops applying the configuration to the aggregation member ports.
If it fails to do that on an aggregation member port, it simply skips the port and moves to the next
port.

Assigning a Hybrid Port to a VLAN

A hybrid port can carry multiple VLANs. You can assign it to a VLAN in interface view (including Ethernet
interface view, Layer 2 aggregate interface view) or port group view.
Follow these steps to assign a hybrid port to one or multiple VLANs:
To do...
Enter system view
Enter Ethernet
interface view
Enter
Enter Layer 2
interface
aggregate
view
interface view
(including
Ethernet
interface
view, Layer
2 aggregate
Enter port
interface
group view
view) or port
group view
Configure the link type of the
port(s) as hybrid
Assign the hybrid port(s) to
the specified VLAN(s)
Configure the default VLAN of
the hybrid port
Use the command...
system-view
interface interface-type
interface-number
interface
bridge-aggregation
interface-number
port-group manual
port-group-name
port link-type hybrid
port hybrid vlan vlan-id-list
{ tagged | untagged }
port hybrid pvid vlan vlan-id
1-9
Remarks
—
Required
Use either command.
In Ethernet interface view, the
subsequent configurations
apply to the current port.
In port group view,
subsequent configurations
apply to all ports in the port
group.
In Layer 2 aggregate interface
view, the subsequent
configurations apply to the
Layer 2 aggregate interface
and all its member ports.
Required
Required
By default, a hybrid port allows
only packets of VLAN 1 to pass
through untagged.
Optional
VLAN 1 is the default by default.
the