Configuring A Remote Source Mirroring Group (On The Source Device) - 3Com S7906E Configuration Manual

The remote source mirroring group on the source device and the remote destination mirroring group on
the destination device must use the same remote probe VLAN.

Configuring a Remote Source Mirroring Group (on the Source Device)

To configure a remote source mirroring group, make the following configurations on the source device:
Creating a remote source mirroring group
Follow these steps to create a remote source mirroring group:
To do...
Enter system view
Create a remote source
mirroring group
Configuring mirroring ports for the remote source mirroring group
You can configure a list of mirroring ports for a mirroring group at a time in system view, or assign only
the current port to it as a mirroring port in interface view. To assign multiple ports to the mirroring group
as mirroring ports in interface view, repeat the step.
Configuring mirroring ports in system view
Follow these steps to configure mirroring ports for the remote source mirroring group in system view:
To do...
Enter system view
Configure mirroring ports for
the remote source mirroring
group
Configuring a mirroring port in interface view
Follow these steps to configure a mirroring port for the remote source mirroring group in interface view:
To do...
Enter system view
Enter interface view
Configure the current port as a
mirroring port
Use the command...
system-view
mirroring-group group-id
remote-source
Use the command...
system-view
mirroring-group group-id
mirroring-port
mirroring-port-list { both |
inbound | outbound }
Use the command...
system-view
interface interface-type
interface-number
[ mirroring-group group-id ]
mirroring-port { both |
inbound | outbound }
1-8
Remarks
—
Required
By default, no mirroring
group exists on a device.
Remarks
—
Required
By default, no mirroring port is
configured for a mirroring
group.
Remarks
—
—
Required
By default, a port does not
serve as a mirroring port for any
mirroring group.