3Com S7906E Configuration Manual page 171

Figure 2-1 Network diagram for super-VLAN configuration
Configuration procedure
# Create VLAN 10, and configure its VLAN interface IP address as 10.0.0.1/24.
<Sysname> system-view
[Sysname] vlan 10
[Sysname-vlan10] interface vlan-interface 10
[Sysname-Vlan-interface10] ip address 10.0.0.1 255.255.255.0
# Enable local proxy ARP.
[Sysname-Vlan-interface10] local-proxy-arp enable
[Sysname-Vlan-interface10] quit
# Create VLAN 2, and assign GigabitEthernet 2/0/1 and GigabitEthernet 2/0/2 to it.
[Sysname] vlan 2
[Sysname-vlan2] port gigabitethernet 2/0/1 gigabitethernet 2/0/2
# Create VLAN 3, and assign GigabitEthernet 2/0/3 and GigabitEthernet 2/0/4 to it.
[Sysname-vlan2] quit
[Sysname] vlan 3
[Sysname-vlan3] port gigabitethernet 2/0/3 gigabitethernet 2/0/4
# Create VLAN 5, and assign GigabitEthernet 2/0/5 and GigabitEthernet 2/0/6 to it.
[Sysname-vlan3] quit
[Sysname] vlan 5
[Sysname-vlan5] port gigabitethernet 2/0/5 gigabitethernet 2/0/6
# Configure VLAN 10 as the super VLAN, and configure VLAN 2, VLAN 3, and VLAN 5 as its
sub-VLANs.
[Sysname-vlan5] quit
[Sysname] vlan 10
[Sysname-vlan10] supervlan
[Sysname-vlan10] subvlan 2 3 5
[Sysname-vlan10] quit
[Sysname] quit
Verification
# Display information about VLAN 10, the super VLAN, to verify the above configuration.
<Sysname> display supervlan
2-3