Configuring The Management Vlan Of The Onu - 3Com S7906E Configuration Manual

This binding method is applicable to occasions where the registration of invalid ONUs is not taken into
consideration and the ONUs attached to the OLT are completely trusted. In this way, concern about
binding is completely ignored. In this case, to remove a binding, disable automatic ONU binding first.
Otherwise, the removed ONU will be automatically bound again only if goes online.
Follow these steps to configure batch ONU binding:
To do...
Enter system view
Enter FTTH view
Configure automatic ONU
binding
Neither batch ONU binding nor automatic ONU binding conflicts with the configuration of binding the
specified ONU to the specified ONU port. However, batch ONU binding conflicts with automatic ONU
binding.

Configuring the Management VLAN of the ONU

To manage an ONU through Telnet, make sure the ONU is assigned an IP address. Only the VLAN
interface corresponding to the management VLAN can be assigned an IP address. You can designate
the management VLAN through the command line.
The management VLAN interface of an ONU can obtain an IP address in one of the following two ways:
Through manual configuration of IP addresses
Through DHCP (with the ONU as a DHCP client)
Follow these steps to configure the management VLAN of the ONU
To do...
Enter system view
Enter ONU port view
Configuring the
management VLAN
of the ONU
Use the command...
system-view
ftth
onu bind auto [ slot slot-id ]
Use the command...
system-view
interface onu interface-number
management-vlan vlan-id
3-4
Remarks
—
—
Required
By default, automatic ONU
binding is disabled.
Remarks
—
—
Optional
By default, the management VLAN of the
ONU is VLAN 1.