Ipv6 Configuration Example - 3Com S7906E Configuration Manual

To do...
Clear the statistics of IPv6 and
ICMPv6 packets (for distributed
devices)
Clear the statistics of IPv6 and
ICMPv6 packets (for distributed
IRF devices)
Clear all IPv6 TCP connection
statistics
Clear the statistics of all IPv6 UDP
packets

IPv6 Configuration Example

Network requirements
Host, Switch A and Switch B are directly connected through Ethernet ports. Add the Ethernet ports
into corresponding VLANs, configure IPv6 addresses for the VLAN interfaces and verify the
connectivity between them.
The aggregatable global unicast addresses of VLAN-interface 2 and VLAN-interface 1 on Switch A
are 3001::1/64 and 2001::1/64 respectively.
The aggregatable global unicast address of VLAN-interface 2 on Switch B is 3001::2/64, and a
route to Host is available.
IPv6 is enabled for Host to automatically get an IPv6 address through IPv6 NDP, and a route to
Switch B is available.
Figure 1-6 Network diagram for IPv6 address configuration
The VLAN interfaces have been created on the switch.
Configuration procedure
Configure Switch A
# Enable IPv6.
<SwitchA> system-view
[SwitchA] ipv6
# Specify an aggregatable global unicast address for VLAN-interface 2.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] ipv6 address 3001::1/64
[SwitchA-Vlan-interface2] quit
Use the command...
reset ipv6 statistics [ slot
slot-number ]
reset ipv6 statistics [ chassis
chassis-number slot slot-number ]
reset tcp ipv6 statistics
reset udp ipv6 statistics
1-21
Remarks
Available in user view
Available in user view
Available in user view
Available in user view