Ipv6 Bgp Route Reflector Configuration - 3Com S7906E Configuration Manual

Total number of peers : 3
Peer
10::2 65008
9:3::2 65009
9:1::2 65009
# Display IPv6 peer information on Switch C.
[SwitchC] display bgp ipv6 peer
BGP local router ID : 3.3.3.3
Local AS number : 65009
Total number of peers : 2
Peer
9:3::1 65009
9:2::2 65009
Switch A and B has established an eBGP connection; Switch B, C and D have established iBGP
connections with each other.

IPv6 BGP Route Reflector Configuration

Network requirements
As shown in the following figure, Switch B receives an eBGP update and sends it to Switch C, which is
configured as a route reflector with two clients: Switch B and Switch D.
Switch B and Switch D need not establish an iBGP connection because Switch C reflects updates
between them.
Figure 1-2 Network diagram for IPv6 BGP route reflector configuration
Vlan-int200
Switch A
100::1/96
Vlan-int200
100::2/96
AS 100
Configuration procedure
1) Configure IPv6 addresses for VLAN interfaces (omitted)
2) Configure IPv6 BGP basic functions
# Configure Switch A.
<SwitchA> system-view
AS MsgRcvd MsgSent
3 3
2 3
2 4
AS MsgRcvd MsgSent
4 4
4 5
Route
reflector
Vlan-int300
101::1/96
Switch C
IBGP
Vlan-int300
101::2/96
AS 200
Switch B
Peers in established state : 3
OutQ PrefRcv Up/Down
0 0 00:01:16 Established
0 0 00:00:40 Established
0 0 00:00:19 Established
Peers in established state : 2
OutQ PrefRcv Up/Down
0 0 00:02:18 Established
0 0 00:01:52 Established
Vlan-int100
102::1/96
IBGP
Vlan-int100
102::2/96
Switch D
1-23
State
State