Qinq Configuration Example - 3Com S7906E Configuration Manual

To do...
Enter the view
of the Ethernet
port/Layer-2
aggregate
interface/port
group
connecting to
the customer
networks
Enable basic QinQ on the port
Apply the QoS policy to the
inbound direction of the port
The configuration of outer VLAN tag priority is achieved through QoS policies. For more information
about QoS policies, refer to the part talking about QoS in the QoS Volume.

QinQ Configuration Example

Network requirements
Provider A and Provider B are service provider network access devices.
Customer A, Customer B, Customer C, and Customer D are customer network access devices.
Provider A and Provider B are interconnected through a trunk port, which permits the frames of
VLAN 1000, VLAN 2000, and VLAN 3000 to pass through.
Third-party devices are deployed between Provider A and Provider B, with a TPID value of 0x8200.
The expected result of the configuration is as follows:
VLAN 10 of Customer A and Customer B can intercommunicate across VLAN 1000 on the public
network.
VLAN 20 of Customer A and Customer C can intercommunicate across VLAN 2000 on the public
network.
Frames of the VLANs other than VLAN 20 of Customer A can be forwarded to Customer D across
VLAN 3000 on the public network.
Use the command...
Enter Ethernet interface interface-type
port view interface-number
Enter Layer-2 interface
aggregate bridge-aggregation
interface view interface-number
Enter port group port-group manual
view port-group-name
qinq enable
qos apply policy
policy-name inbound
1-10
Remarks
Use either of the three
commands.
Configurations made in
Ethernet port view take
effect only on the current
port.
Configurations made in
Layer-2 aggregate
interface view take effect
on the Layer-2 aggregate
interface and the member
ports in the aggregation
group corresponding to
the Layer-2 aggregate
interface.
Configurations made in
port group view
effect on all ports in the
port group.
Required
Required
take