Policy Routing Configuration Examples; Ipv4 Policy Routing Configuration Example - 3Com S7906E Configuration Manual

To do...
Display VLAN QoS policy
configuration on a distributed
IRF device
Display information about
global QoS policies on a
distributed device
Display information about
global QoS policies on a
distributed IRF device

Policy Routing Configuration Examples

IPv4 Policy Routing Configuration Example

Network requirements
As shown in Figure
hop 202.1.1.2.
Figure 1-1 Network diagram for IPv4 policy routing configuration
Configuration procedure
# Configure ACL 2000.
<SwitchA> system-view
[SwitchA] acl number 2000
[SwitchA-acl-basic-2000] rule 0 permit source any
[SwitchA-acl-basic-2000] quit
# Define a match criterion for class a to match ACL 2000.
[SwitchA] traffic classifier a
[SwitchA-classifier-a] if-match acl 2000
[SwitchA-classifier-a] quit
# Configure the action of redirecting traffic to the next hop 202.1.1.2 for behavior a.
[SwitchA] traffic behavior a
Use the command...
display qos vlan-policy
{ name policy-name | vlan
[ vlan-id ] } [ chassis
chassis-number slot
slot-number ] [ inbound |
outbound ]
display qos policy global
[ slot slot-number ] [ inbound |
outbound ]
display qos policy global
[ chassis chassis-number slot
slot-number ] [ inbound |
outbound ]
1-1, redirect all packets received on GigabitEthernet 2/0/1 of Switch A to the next
Available in any view
Available in any view
Available in any view
1-4
Remarks