Configuring The Monitor Port For A Local Mirroring Group - 3Com S7906E Configuration Manual

To do...
Enter interface view
Configure the current port as a
mirroring port
A mirroring group can contain multiple mirroring ports.

Configuring the Monitor Port for a Local Mirroring Group

On the source device, configure the tunnel interface as the monitor port; on the destination device,
configure the port that connects the data monitoring device as the monitor port.
You can configure the monitor port for a mirroring group in system view, or assign the current port to a
mirroring group as the monitor port in interface view. The two modes lead to the same result.
Configuring the monitor port in system view
Follow these steps to configure the monitor port for a local mirroring group in system view:
To do...
Enter system view
Configure the monitor port
Configuring the monitor port in interface view
Follow these steps to configure the monitor port for a local mirroring group in interface view:
To do...
Enter system view
Enter interface view
Configure the current port as
the monitor port
Use the command...
interface interface-type
interface-number
[ mirroring-group group-id ]
mirroring-port { both |
inbound | outbound }
Use the command...
system-view
mirroring-group group-id
monitor-port monitor-port-id
Use the command...
system-view
interface interface-type
interface-number
[ mirroring-group group-id ]
monitor-port
1-14
Remarks
—
Required
By default, a port does not
serve as a mirroring port for any
mirroring group.
Remarks
—
Required
By default, no monitor port is
configured for a mirroring
group.
Remarks
—
—
Required
By default, a port does not
serve as the monitor port for
any mirroring group.