Configuring Rip Network Optimization; Configuring Rip Timers - 3Com S7906E Configuration Manual

To do...
Enter RIP view
Configure a default metric for
redistributed routes
Redistribute routes from
another protocol
Only active routes can be redistributed. You can use the display ip routing-table protocol command
to display route state information.

Configuring RIP Network Optimization

Complete the following tasks before configuring RIP network optimization:
Configure network addresses for interfaces, and make neighboring nodes reachable to each other;
Configure RIP basic functions.

Configuring RIP Timers

You can change the RIP network convergence speed by adjusting RIP timers.
Follow these steps to configure RIP timers:
To do...
Enter system view
Enter RIP view
Configure values for RIP timers
Use the command...
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
default cost value
import-route protocol
[ process-id | all-processes |
allow-ibgp ] [ cost cost |
route-policy
route-policy-name | tag tag ] *
Use the command...
system-view
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
timers { garbage-collect
garbage-collect-value |
suppress suppress-value |
timeout timeout-value | update
update-value } *
1-12
Remarks
––
Optional
The default metric of a
redistributed route is 0 by
default.
Required
No redistribution is configured
by default.
Remarks
––
––
Optional
The default update timer,
timeout timer, suppress timer,
and garbage-collect timer are
30s, 180s, 120s and 120s
respectively.