Configuring Outbound Route Filtering - 3Com S7906E Configuration Manual

To do...
Enter system view
Enter BGP view
Enter IPv6 address family
view
Advertise a default route to
an IPv6 peer/peer group
With the peer default-route-advertise command executed, the local router advertises a default route
with itself as the next hop to the specified IPv6 peer/peer group, regardless of whether the default route
is available in the routing table.

Configuring Outbound Route Filtering

Follow these steps to configure outbound route filtering:
To do...
Enter system view
Enter BGP view
Enter IPv6 address family view
Configure the filtering of
outgoing routes
Apply a routing policy to routes
advertised to an IPv6 peer/peer
group
Specify an IPv6 ACL to filer
routes advertised to an IPv6
peer/peer group
Specify an AS path ACL to filer
routes advertised to an IPv6
peer/peer group
Specify an IPv6 prefix list to filer
routes advertised to an IPv6
peer/peer group
Use the command...
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name | ipv6-address }
default-route-advertise [ route-policy
route-policy-name ]
Use the command...
system-view
bgp as-number
ipv6-family
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
export [ protocol process-id ]
peer { ipv6-group-name |
ipv6-address } route-policy
route-policy-name export
peer { ipv6-group-name |
ipv6-address } filter-policy
acl6-number export
peer { ipv6-group-name |
ipv6-address } as-path-acl
as-path-acl-number export
peer { ipv6-group-name |
ipv6-address } ipv6-prefix
ipv6-prefix-name export
1-8
Remarks
—
—
—
Required
Not advertised by
default.
Remarks
—
—
—
Required
Not configured by default.
Required
Not applied by default.
Required
Not specified by default.
Required
Not specified by default.
Required
Not specified by default.